• Prototype manufacturer of electric motors & generators

Mechanical


 Dimensions:

  1. Outside diameter: 1.61 in. ( 40.9mm) with or without cap for 1.28 in. (32.5mm) mounting pattern; 2.05 in. (52.1mm) when 1.81 in. (46mm) bolting pattern is used –
  2. Wire and connector clearance: 1.81 in. (46mm)
  3. Height: 0.68 in. (173mm) with cap
  4.  Encoder wheel hubs to fit shaft sizes: 1/8 in., 3/16 in., 5 mm, 6 mm, 1/4 in., 5/16 in, 8 mm, 3/8 in., 10 mm

■ Encoder wheel hub material: steel with flash nickel plating

■ Encoder wheel magnet material: nitrile-bonded ferrite
■ Encoder wheel method of attachment: set screw (3mm) aligned with index pulse – if applicable

■ Encoder wheel moment of inertia: < 0.125 oz-in sect

■ Maximum RPM: 10,000 RPM
■ Housing: high temperature glass-filled nylon

■ Mounting screws: M2.5 or #2-56 (thread locker recommended)

■ Air gap: set by e-z gauge

■ Weight: 1.0 oz. (28 grams)

Electrical

■ Output: two channels in quadrature with gated index and optional commutation
■ Resolution: 100, 125, 128, 160, 200, 250, 256, 320, 400, 500, 512, 640, 800, 1000, 1024, 1280, moo, 2048 lines per channel
■ Commutation: 4/6/8/12 poles’
■ Supply voltage: 5VDC ±10%
■ Output format: line driver (26C31) or open collector
■ Current requirements: 39 mA plus commutation halls and output load 126031)
■ Frequency response: 200 kHz (800 kHz data rate)
■ Output terminations: 15-pin

Enviornmental

■ Enclosure rating: NEMA 1 / IP40 for models with cover with no center hole

■ Operating temperature: -40° to 125°C open collector, -40° to 85°C for line driver

■ Storage temperature: -55° to 150°C

■ Humidity: 98% relative humidity without nrindRocatinn